PhosGuard, for removing phosphates and silicates - Seachem

PhosGuard is able to remove 20-60 mg of phosphates and as many silicates. It can be used periodically or continuously without the risk of assigning a part of the absorbed phosphates. Reduces filamentous algae and promotes coral growth.

To get the best results, PhosGuard must be positioned so as to maximize the flow of water through it. It can be placed directly in the filter or in any high flow zone.

Instructions:

Use 250 mL every 300 liters of water. Allow the product to act for 4 days and test phosphates and silicates using Multitest: Phosphate or Multitest: Silicate. If the concentration of the components you are trying to decrease did not lower 02 mg, replace the phosguard ™, if the concentration of the component you are trying to decrease has not dropped to about 0.02 mg, leave the product until the levels begin To go up again. As long as they remain under control, the product is not exhausted. 500 ml of phosguard treat over 400 l (ie they remove up to 30 mg of phosphate in 400 l of water, depending on the initial concentration of phosphate / silicate as well as the existing biological load. No longer recommended for a treatment. PhosGuard ™ is not an exchange of resin, it does not release anything in the water. Continuous use of small quantities is preferable to intermittent use of larger quantities.

Attention: It can generate heat to the first contact with water. Protect yourself with adding a double volume of fresh water (for example, 250 ml of product in 500 ml of water).