Taifun Extend Co2 reactor Proflora JBL JBL CO2 Proflora Reactor Extend Full Staff Extension Module with Suction cup

If cleaning is necessary, simply disassemble the unit by pulling the modular sections separately. After cleaning, simply reassemble the unit using the modular sections with snap sections that prevent the interruption of the bubbles. Wash the entire unit completely in hot tap water. Don't use detergents!

Install in vertical position the Vario reactor CO2 in a aquarium point with a moderate water movement, with the upper edge of the unit immersed at least 2 cm below the water level.

Connecting the CO2 connection tube appropriately, allows at first the passage of some flow bubbles through the unit.

When using the drive for the first time, the bubbles will slowly rise from below up along the bubble spiral path. The unit takes about 48 hours in time. The biological film that is formed in this time frame allows bubbles to rise without obstacles.

On their way up the bubbles shrink allowing CO2 to spread in the surrounding waters. Once the top is reached, the bubbles pass into the harvesting CAP where any remaining CO2 residues are spread completely.

After a certain time the collecting cap will fill with gas that occasionally escapes upward through the ventilation cracks on the side. This gas is not CO2, but what is known as false gas that is found in small quantities in the bottles of CO2 is that it also spreads in the bubbles that rise through the surrounding water.

Clean the various CO2 as rarely as possible. It is therefore advisable to connect the unit to a fairly dark point in the aquarium with a proper water movement.

To ensure optimal diffusion, make sure that the cracks between the modular sections are not blocked by segments of plants or decorative objects.