Reef Test Kit Magnesium Pro

High precision magnesium test

Instructions about the magnesiumpro test kit

1. Using the large syringe supplied, inject exactly 2 ml of water to be tested

In the glass vault.

2. Add 5 drops of MG Pro Reagent A, waving the ampoule for 15 seconds after adding

of each drop.

3. Add 5 drops of MG Pro Reagent B and mix the reagent slowly with the sample

of water.

4. Screw the glass ampoule to the base of the titrant solution for about 60 seconds until the

Sample test will obtain the starting color as shown on the instruction map. To the base

The ampoule will form a precipitate.

5. Make sure the needle supplied is located on the 1ml titration syringe and fill with

1 ml of magnesium pro titrant (c). [see note about the loading of the syringe for the

titration]

6. Insert the syringe to the center of the titrant solution so that the sized series on the part

Side of the syringe is visible. The graduated series degrees are 0.01 ml, equivalent to 20

magnesium ppm.

7. Add 0.4 ml of the titrant solution (corresponding to 800ppm of magnesium)

Pressing the syringe plunger by slowly mixing the titrant solution. Continue

to add the solution gradually, stirring it after each addition, doing

Attention to color in the ampoule. When the color in the Ampolla approaches the final color

of the instructions card, add a drop at a time and mix immediately afterwards, up to

Reach the final color (blue).

Note: immediately after reaching the final blue color, the liquid in the ampoule will become purple. Not continue to

Add the titrant solution if you have used more than 0.8ml of owner solution, you don't reach the point

Final and you will have to redo the test.

8. Write down the amount of titrant solution used (depending on the initial and final position

of the plunger, not the liquid surface) and use the table to calculate the level of

Magnesium in the water sample.

9. Publish the amount of solution titrant not used in the bottle of the magnesium Pro Titrant C.