marine water inout tracimator with Ø 20x26 mm flow

Overflow complete with suction grid and directional water jet system.

OVERFLOW complete with: anti-obstruction and removable suction grid for correct cleaning; Adjustable management system of the water jet; Water loading and drain pipes *. Compared to the previous model, the internal flow rate of the ski was increased. The fall and other features remained unchanged. Installable in aquariums with SUMP external filter and 2 wall holes as diagram. Externally applies, the volume of the tank remains unchanged. The specific interior conformation gives it maximum silence. Water flow from the pump with wave effect. For maintenance operations, such as cleaning the pipes, it is sufficient to lower the water level of 4 cm. There is no need to drill the base of the tank, excludes all the risks of water loss possible with conventional Owerflow. Injection printed with high strength, non-toxic and shockproof plastic. Maximum pump range 2500 l / h. Prepared to be divided into two parts and thus obtain the delivery and the fall of separate water. External dimensions: L = 12, p = 5, h = 6 cm.

Included in the package:

- 1 inout complete with grid with support, 2 nuts and water outlet nozzle.

- 1 water loading tubing in black silicone. Length: 1.5 m - Ø 20x26 mm *.

- 1 water drain out piping in black non-toxic silicone plastic. Length 1.5 mt - Ø 40x46 mm *.

- 1 adhesive template for the construction of the holes on the tank.

Installation: To ensure a hermetic seal, this device is equipped with O-Rings directly printed on the exhaust. Installed the inout, these will be externally to the aquarium.

Place the inout by entering the appropriate holes. Insert the support for the grill inside the drain nozzle and tighten the nuts with your hands by applying a minimum pressure, without using mechanical tools. Then apply the grid in the appropriate support and the nozzle in the load nozzle. To insert the nozzle immerse it into boiling water for a few seconds. Then connect the water inlet and outlet pipes, making sure there are no leaks when using the exhaust.

It is important that the glass holes are perfectly calibrated to ensure proper water seal. The distances and the minimum and maximum diameter of the holes are indicated in the drilling scheme. The greater the diameter of the holes, the greater the precision of the distances to be respected. The Dima-Guide indicates exactly the distance from the edge (in height), the diameter and distance between the holes to be respected. Place the inout so that ORINGs are centered at the hole. Clean the pipes before use. Periodically clean the pump and pipes to keep the inout efficient.

* Included only in the version with pipes.

It is possible to request the pipes:
1 Water loading tubing in black-colored silicone of 1,5 mt.
1 Outlet water piping in black-colored plastic material of 1.5 m.